This rack contains:
1x XTA DP224 Speaker Processor 2x EV Q66 Amplifiers 2x QSC RMX 2450 Amplifiers 2x QSC RMX1850 Amplifiers Built in mains and signal cabling. The rack is configurable for different situations, but it is basically designed for the following default arrangement:
Both Q66 amps are bridged and each feed a pair of EV ZX5 Speakers for main L and R PA. 1.2kW per side Both RMX 2450 amps are bridged and each feed an EV Xsub speaker for L and R sub. 2.4kW per side Both RMX 1850 amps operate in dual mono / stereo mode to feed 4 separate monitor mixes, each with 1 or more Turbosound Txd-12m monitor wedges. The Q66 and 2450 amps are fed via the XTA DP224 for full control of crossovers and limiters etc. The 1850 amps are fed directly from the mixer. The speaker output signal patch on the rack is configured with the above arrangement in mind, and is designed to use our multiway speaker cable drums, as pictured, which are included in the rack price. Note that the loudspeakers are not included in the rack price.
The XTA processor can be connected to a laptop via an interface cable for easier control of its settings, if there is a wifi network available this also allows smartphone or tablet control of the XTA. The rack can be re-configured in many different ways. For example, we sometimes change the XTA DP224 for a DP226, then use 1 or more mono sum signals to feed the 1850 amps which then feed delay speakers. There is space in the rack for a second XTA processor, and the bridged amps can be un-bridged, so the rack can be re-configured to give 12 independent speaker outputs.
If you need a config different to the default one described above please let us know and we can advise and set-up the rack for you.
There are 3x 16A single phase mains supplies into to the rack. A 13A power outlet is included on the rack for powering control laptops and the like.